Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 107)

107 | Wired Profiles AOS-W Instant 6.3.1.1-4.0 | User Guide

To configure unrestricted access:

(Instant Access Point)(config)# wired-port-profile <name>

(Instant Access Point)(wired ap profile <name>)# set-role-unrestricted

(Instant Access Point)(wired ap profile <name>)# end

(Instant Access Point)# commit apply

Understanding Hierarchical Deployment

AnOAW-IAP Series or OAW-RAP3WN (with more than one wired port) can be connected to the downlink wired port

of another OAW-IAP (ethX). AnOAW-IAP with a single Ethernet port (like OAW-IAP90 or OAW-IAP100 series

devices) can be provisioned to use Ethernet bridging, so that Ethernet 0 port is converted to a downlink wired port.

You can also form anOAW-IAP network by connecting the downlink port of an AP to other APs. Only one AP in the

network uses its downlink port to connect to the other APs. This AP (called the root AP) acts as the wired device for

the network, provides DHCP service and an L3 connection to the ISP uplink with NAT. The root AP is always the

master of the Instant network. In a single Ethernet port platform deployment, the root AP must be configured to use

the 3G uplink.

A typical hierarchical deployment consists of the following:

l A direct wired ISP connection or a wireless uplink.

l One or more DHCP pools for private VLANs.

l One downlink port configured on a private VLAN without authentication for connecting to slave APs. Ensure that

the downlink port configured in a private VLAN is not used for any wired client connection. Other downlink ports

can be used for connecting to the wired clients.

The following figure illustrates a hierarchical deployment scenario:

Figure 39 Hierarchical Deployment

Configuring Wired Bridging on Ethernet 0

AOS-W Instant supports wired bridging on the Ethernet 0 port of an OAW-IAP.

1 2 ... 102 103 104 105 106 107 108 109 110 111 112 ... 334 335

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 107