Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 176)

You can also create a user role when configuring wireless or wired network profiles. For more information, see

Configuring Access Rules for a WLAN SSID Profile on page 95 and Configuring Access Rules for a Wired Profile on

page 105

In the CLI

To configure user roles and access rules:

(Instant Access Point)(config)# wlan access-rule <access-rule-name>

(Instant Access Point)(Access Rule <Name>)# rule <dest> <mask> <match> <protocol> <start-port>

<end-port> {permit |deny | src-nat | dst-nat {<IP-address> <port> | <port>}}[<option1…option

9>]

Assigning Bandwidth Contracts to User Roles

The administrators can manage bandwidth utilization by assigning maximum bandwidth rates, or bandwidth

contracts to user roles. The administrator can assign a bandwidth contract configured in Kbps to upstream (client to

the OAW-IAP) or downstream (OAW-IAP to clients) traffic for a user role. The bandwidth contract will not be

applicable to the user traffic on the bridged out (same subnet) destinations. For example, if clients are connected to

an SSID, you can restrict the upstream bandwidth rate allowed for each user to 512 Kbps.

By default, all users that belong to the same role share a configured bandwidth rate for upstream or downstream

traffic. The assigned bandwidth will be served and shared among all the users. You can also assign bandwidth per

user to provide every user a specific bandwidth within a range of 1 to 65535 Kbps. If there is no bandwidth contract

specified for a traffic direction, unlimited bandwidth is allowed.

In the earlier releases, bandwidth contract could be assigned per SSID. In the current release, the bandwidth

contract can also be assigned for each SSID user. If the bandwidth contract is assigned for an SSID in AOS-W

Instant 6.2.1.0-3.4.0.0 image and when the OAW-IAP is upgraded to 6.3.1.1-4.0 release version, the bandwidth

configuration per SSID will be treated as per-user downstream bandwidth contract for that SSID.

Assigning Bandwidth Contracts in the AOS-W InstantUI

1. Click the Security at the top right corner of AOS-W Instant main window. The Security window is displayed.

2. Click Roles tab. The Roles tab contents are displayed.

3. Create a new role or select an existing role.

4. Under Access Rules, click New. The New Rule window is displayed.

5. Select Bandwidth Contract from the Rule Type drop-down.

6. Specify the downstream and upstream rates in Kbps. If the assignment is specific for each user, select the

Peruser checkbox.

7. Click OK.

8. Associate the user role to a WLANSSID or wired profile.

You can also create a user role and assign bandwidth contracts while configuring an SSID or wired profile.

Assigning a bandwidth contract using AOS-W Instant CLI:

To assign a bandwidth contract in the CLI:

AOS-W Instant 6.3.1.1-4.0 | User Guide Roles and Policies | 176

1 2 ... 171 172 173 174 175 176 177 178 179 180 181 ... 334 335

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 176