Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 196)

196 | Uplink Configuration AOS-W Instant 6.3.1.1-4.0 | User Guide

Uplink Preferences and Switching

This topic describes the following procedures:

l Enforcing Uplinks on page 196

l Setting an Uplink Priority on page 196

l Enabling Uplink Preemption on page 197

l Switching Uplinks Based on VPN and Internet Availability on page 197

l Viewing Uplink Status and Configuration on page 199

Enforcing Uplinks

The following configuration conditions apply to the uplink enforcement:

l When an uplink is enforced, the OAW-IAP uses the specified uplink regardless of uplink preemption configuration

and the current uplink status.

l When an uplink is enforced and multiple Ethernet ports are configured and uplink is enabled on the wired profiles,

the OAW-IAP tries to find an alternate Ethernet link based on the priority configured.

l When no uplink is enforced and preemption is not enabled, and if the current uplink fails, the OAW-IAP tries to

find an available uplink based on the priority configured.

l When no uplink is enforced and preemption is enabled, and if the current uplink fails, the OAW-IAP tries to find an

available uplink based on in the priority configured. If current uplink is active, the OAW-IAP periodically tries to

use a higher priority uplink and switches to the higher priority uplink even if the current uplink is active.

You can enforce a specific uplink on an OAW-IAP by using the AOS-W Instant UI or CLI.

In the AOS-W Instant UI

To enforce an uplink:

1. Click the System > show advanced settings > Uplink. The Uplink tab contents are displayed.

2. Under Uplink Management, select the type of uplink from the Enforce Uplink drop-down list. If Ethernet uplink

is selected, the Port field is displayed.

3. Specify the Ethernet interface port number.

4. Click OK. The selected uplink is enforced on the OAW-IAP.

In the CLI

To enforce an uplink:

(Instant Access Point)(config)# uplink

(Instant Access Point)(uplink)# enforce {cellular|ethernet|wifi|none}

(Instant Access Point)(uplink)# end

(Instant Access Point)# commit apply

Setting an Uplink Priority

You can set an uplink priority by using the AOS-W Instant UI or CLI.

In the AOS-W Instant UI

1. Click the System > show advanced settings > Uplink. The Uplink tab contents are displayed.

2. Under Uplink Priority List, select the uplink, and click the icons at the bottom of the Uplink Priority List section,

to increase or decrease the priority. By default, the Eth0 uplink is set as a high priority uplink.

3. Click OK. The selected uplink is prioritized over other uplinks.

1 2 ... 191 192 193 194 195 196 197 198 199 200 201 ... 334 335

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 196