Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 153)

153 | Authentication AOS-W Instant 6.3.1.1-4.0 | User Guide

(Instant Access Point)(SSID Profile <name>)# opmode {wpa2-aes|wpa-tkip|wpa-tkip,wpa2-aes|dynam

ic-wep}

(Instant Access Point)(SSID Profile <name>)# leap-use-session-key

(Instant Access Point)(SSID Profile <name>)# termination

(Instant Access Point)(SSID Profile <name>)# external-server

(Instant Access Point)(SSID Profile <name>)# auth-server <server-name>

(Instant Access Point)(SSID Profile <name>)# radius-reauth-interval <minutes>

(Instant Access Point)(SSID Profile <name>)# auth-survivability

(Instant Access Point)(SSID Profile <name>)# exit

(Instant Access Point)(config)# auth-survivability cache-time-out <hours>

(Instant Access Point)(config)# end

(Instant Access Point)# commit apply

Configuring 802.1X authentication for Wired Profiles

You can configure 802.1X authentication for a wired profile in the AOS-W Instant UI or CLI.

In the AOS-W Instant UI

To enable 802.1X authentication for a wired profile:

1. Click the Wired link under More at the top right corner of the AOS-W Instant main window. The Wired window is

displayed.

2. Click New under Wired Networks to create a new network or select an existing profile for which you want to

enable 802.1X authentication and then click Edit.

3. In the New Wired Network or the Edit Wired Network window, ensure that all the required Wired and VLAN

attributes are defined, and then click Next.

4. In the Security tab, select Enabled from the 802.1X authentication drop-down list.

5. Specify the type of authentication server to use and configure other required parameters. For more information on

configuration parameters, see Configuring Security Settings for a Wired Profile on page 104

6. Click Next to define access rules, and then click Finish to apply the changes.

7. Assign the profile to an Ethernet port. For more information, see Assigning a Profile to Ethernet Ports on page

108.

In the CLI

To enable 802.1X authentication for a wired profile:

(Instant Access Point) (config)# wired-port-profile <name>

(Instant Access Point) (wired ap profile <name>)# type {<employee> |<guest>}

(Instant Access Point) (wired ap profile <name>)# dot1x

(Instant Access Point) (wired ap profile <name>)# auth-server <server1>

(Instant Access Point) (wired ap profile <name>)# server-load-balancing

(Instant Access Point) (wired ap profile <name>)# radius-reauth-interval <Minutes>

(Instant Access Point) (wired ap profile <name>)# end

(Instant Access Point)# commit apply

Configuring MAC Authentication for a Network Profile

MAC authentication can be used alone or it can be combined with other forms of authentication such as WEP

authentication. However, it is recommended that you do not use the MAC-based authentication.

This section describes the following procedures:

l Configuring MAC Authentication for Wireless Network Profiles on page 154

1 2 ... 148 149 150 151 152 153 154 155 156 157 158 ... 334 335

Kommentare zu diesen Handbüchern

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 153

Kommentare zu diesen Handbüchern