Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 129)

129 | User Management AOS-W Instant 6.3.1.1-4.0 | User Guide

2. Click the Admin tab. The Admin tab details are displayed. The following figure shows the contents of the Admin

tab:

Figure 42 Admin Tab: Management Authentication Parameters

3. Under Local, select any of the following options from the Authentication drop-down list:

l Internal— Select this option to specify a single set of user credentials. Enter the Username and Password for

accessing the Virtual Controller Management User Interface.

a. Specify a Username and Password.

b. Retype the password to confirm.

l RADIUS Server— Specify one or two RADIUS servers to authenticate clients. If two servers are configured,

users can use them in primary or backup mode or load balancing mode. To enable load balancing, select

Enabled from the Load balancing drop-down list.

l RADIUS server w/ fallback to internal— Select this option to use both internal and external servers. When

enabled, the authentication switches to Internal if there is no response from the RADIUS server (RADIUS

server timeout). To complete this configuration, perform the following steps:

a. To enable load balancing, select Enabled from the Load balancing drop-down list.

4. Click OK.

In the CLI

To configure an admin user:

(Instant Access Point)(config)# mgmt-user <username> [password]

(Instant Access Point)(config)# end

(Instant Access Point)# commit apply

To configure RADIUS authentication parameters:

(Instant Access Point)(config)# mgmt-auth-server <authentication_server1>

(Instant Access Point)(config)# mgmt-auth-server <authentication_server2>

(Instant Access Point)(config)# mgmt-auth-server-load-balancing

(Instant Access Point)(config)# mgmt-auth-server-local-backup

(Instant Access Point)(config)# end

1 2 ... 124 125 126 127 128 129 130 131 132 133 134 ... 334 335

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 129