Alcatel-Lucent IAP93 Betriebsanweisung Seite 60
- Seite / 335
- Inhaltsverzeichnis
- FEHLERBEHEBUNG
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
l Association Time— The time at which the selected client was associated with a particular OAW-IAP.
The AOS-W Instant UI shows the client and OAW-IAP association over the last 15 minutes.
l Access Point— The OAW-IAP name with which the client was associated.
Mobility information about the client is reset each time it roams from one OAW-IAP to another.
Spectrum
The spectrum link (in the Access Point view) displays the spectrum data that is collected by a hybrid AP or by an
OAW-IAP that has enabled spectrum monitor. The spectrum data is not reported to the Virtual Controller.
The spectrum link displays the following:
l Device list - The device list display consists of a device summary table and channel information for active non
Wi-Fi devices currently seen by a spectrum monitor or hybrid AP radio.
l Channel Utilization and Monitoring - This chart provides an overview of channel quality across the spectrum. It
shows channel utilization information such as channel quality, availability, and utilization metrics as seen by a
spectrum monitor for the 2.4 GHz and 5 GHz radio bands. The first bar for each channel represents the
percentage of air time used by non Wi-Fi interferers and Wi-Fi devices. The second bar indicates the channel
quality. A higher percentage value indicates better quality.
l Channel Details - When you move your mouse over a channel, the channel details or the summary of the 5 GHz
and 2.4 GHz channels as detected by a spectrum monitor are displayed. You can view the aggregate data for
each channel seen by the spectrum monitor radio, including the maximum AP power, interference and the Signal-
to-Noise and Interference Ratio (SNIR). Spectrum monitors display spectrum analysis data seen on all channels
in the selected band, and hybrid OAW-IAPs display data from the one channel they are monitoring.
For more information on spectrum monitoring, see Spectrum Monitor on page 203.
Alerts
Alerts are generated when a user encounters problems while accessing or connecting to a network. The alerts that
are generated on AOS-W Instant can be categorized as follows:
l 802.11 related association and authentication failure alerts
l 802.1X related mode and key mismatch, server, and client time-out failure alerts
l IP address related failures - Static IP address or DHCP related alerts.
The following figure shows the contents of details displayed on clicking the Alerts link:
Figure 22 Alerts Link
AOS-W Instant 6.3.1.1-4.0 | User Guide AOS-W Instant User Interface | 60
- User Guide 1
- AOS-W Instant 1
- 6.3.1.1-4.0 1
- Contents 3
- In the AOS-W Instant UI 71 5
- In the CLI 72 5
- Mesh OAW-IAP Configuration 79 6
- VLAN Configuration 81 6
- Wireless Network Profiles 85 7
- Wired Profiles 102 8
- In the CLI 121 9
- User Management 128 10
- Authentication 134 10
- In the AOS-W Instant UI 148 11
- In the CLI 149 11
- In the AOS-W Instant UI 149 11
- In the AOS-W Instant UI 159 12
- In the CLI 160 12
- Roles and Policies 164 13
- Example 180 14
- Example 183 14
- In the AOS-W Instant UI 185 14
- Uplink Configuration 187 15
- Spectrum Monitor 203 16
- Adaptive Radio Management 211 16
- Intrusion Detection 221 17
- Content Filtering 228 17
- DHCP Configuration 231 17
- VPN Configuration 239 18
- IAP-VPN Configuration 252 18
- In the AOS-W Instant UI 261 19
- In the CLI 262 19
- AirGroup Configuration 268 20
- Hotspot Profiles 287 21
- Extended Voice and Video 301 22
- Dynamic CPUManagement 302 22
- OAW-IAP Management 304 22
- Regulatory Domain 322 23
- ClearPass Guest Setup 327 23
- Terminology 331 23
- Intended Audience 25
- Related Documents 25
- Conventions 25
- Contacting Support 26
- AOS-W Instant Overview 27
- AOS-W Instant UI 28
- AOS-W Instant CLI 28
- New Features in 6.3.1.1-4.0 29
- Platform 31
- Description 31
- Chapter 3 32
- Setting up an OAW-IAP 32
- Assigning a Static IP 33
- OAW-IAP Cluster 33
- 9600 8 None 1 None 34
- Specifying Country Code 35
- Connecting to a CLI Session 35
- Sequence-Sensitive Commands 37
- Login Screen 38
- Main Window 39
- Networks Tab 40
- Access Points Tab 40
- Clients Tab 41
- New Version Available 41
- Security 44
- Maintenance 45
- Monitoring 51
- Table 7: 52
- RF Dashboard Icons 53
- Icon Name Description 54
- RF Trends 54
- Figure 17 Signal Graph 54
- Table 9: 56
- Table 10: 57
- Spectrum 60
- Types of Alerts 61
- Alerts list 62
- Configuration 64
- AirGroup 65
- OmniVista 3600 Setup 65
- Pause/Resume 65
- Chapter 5 67
- Initial Configuration Tasks 67
- Modifying the OAW-IAP Name 68
- Configuring External Antenna 69
- Upgrading an OAW-IAP 70
- Enabling Terminal Access 73
- Enabling Auto Join Mode 74
- Configuring a Preferred Band 74
- Configuring an NTP Server 77
- Mesh Network Overview 79
- Mesh Points 80
- Chapter 7 81
- VLAN Configuration 81
- Virtual Controller Overview 82
- Antenna Type:Internal 83
- Iap_master:1 83
- Chapter 9 85
- Wireless Network Profiles 85
- WLAN Configuration Parameters 87
- Security Level 93
- Table 18: 93
- 802.11r Roaming 97
- Opportunistic Key Caching 98
- Enabling the Extended SSID 100
- Editing a WLAN SSID Profile 101
- Deleting a WLAN SSID Profile 101
- Configuring a Wired Profile 102
- In the CLI 103
- In the AOS-W Instant UI 103
- Editing a Wired Profile 108
- Deleting a Wired Profile 109
- Understanding Captive Portal 110
- Walled Garden 111
- Parameters Description 112
- In the Instant UI 116
- RADIUS Services 121
- OAW-IAP Users 128
- Interface 128
- 5. Click OK 133
- Chapter 13 134
- Authentication 134
- External RADIUS Server 136
- Internal RADIUS Server 136
- Supported VSAs 137
- WPA and WPA2 141
- Access-Accept 142
- Parameter Description 145
- Table 27: 145
- Table 28: 146
- Enabling Dynamic RADIUS Proxy 148
- Management Interface 150
- Blacklisting Clients 158
- Blacklisting Clients Manually 159
- Uploading Certificates 160
- Figure 54 Selecting the Group 163
- Firewall Configuration 164
- Managing Inbound Traffic 167
- Access Control List Rules 169
- Field Description 170
- Table 30: 170
- Configuring User Roles 175
- Configuring Derivation Rules 178
- Understanding VLAN Assignment 180
- User Role 182
- VLANs Created for an SSID 182
- Creating a User VLAN Role 185
- Uplink Interfaces 187
- Ethernet Uplink 188
- 3G/4G Uplink 190
- List of Supported 3G Modems 191
- 4G Supported Modem 192
- Wi-Fi Uplink 194
- Enforcing Uplinks 196
- Setting an Uplink Priority 196
- Enabling Uplink Preemption 197
- Layer-3 Mobility Overview 200
- Configuring L3-Mobility 201
- Understanding Spectrum Data 203
- Non Wi-Fi Interferers 204
- Non Wi-Fi Interferer Types 205
- Channel Details 206
- Channel Metrics 207
- Spectrum Alerts 208
- ARM Overview 211
- Airtime Fairness Mode 212
- ARM Metrics 213
- Figure 71 RF Window - ARM Tab 214
- Table 38: 214
- To view ARM configuration: 217
- OS Fingerprinting 221
- Table 43: 223
- Client Detection Policies 224
- Client Protection Policies 225
- Configuring IDSUsing CLI 226
- Content Filtering 228
- Enabling Content Filtering 228
- Configuring DHCP Scopes 231
- Name Description 232
- Table 47: 232
- Understanding VPN Features 239
- Configuring an L2TPv3 Tunnel 244
- To view L2TPv3 configuration: 247
- To view L2TPV3 tunnel status: 248
- To view L2TPv3 tunnel config: 249
- Configuring Routing Profiles 250
- Overview 252
- IAP-VPN Scalability Limits 253
- OSPFConfiguration 253
- VPN Configuration 255
- Viewing Branch Status 256
- Omnivista Features 258
- Trending Reports 259
- Intrusion Detection System 259
- Configuring Omnivista 260
- Shared Key 261
- Figure 97 Omnivista —Monitor 267
- AirGroup Overview 268
- AirGroup with AOS-W Instant 269
- AirGroup Solution 270
- AirGroup Features 271
- AirGroup Components 272
- AirGroup Services 272
- Creating a RADIUS Server 275
- Assign a Server to AirGroup 275
- Chapter 26 276
- Chapter 27 281
- Client Traffic Replication 283
- Creating a CALEA Profile 283
- Verifying the configuration 285
- Chapter 28 287
- Hotspot Profiles 287
- Configuring Hotspot Profiles 288
- Venue Types 291
- Configuring a 3GPP Profile 293
- Configuring a Domain Profile 293
- Creating a Hotspot Profile 295
- Table 57: 296
- Sample Configuration 298
- Chapter 29 301
- Extended Voice and Video 301
- Dynamic CPU Management 302
- Chapter 31 303
- Configuring LED Display 304
- Restoring Configuration 305
- Rebooting the OAW-IAP 309
- Configuring SNMP 311
- Configuring a Syslog Server 314
- Logging Levels 315
- Configuring TFTP Dump Server 316
- Support Commands 317
- Country Codes List 322
- Code Country Name 323
- ClearPass Guest Setup 327
- Troubleshooting 330
- Acronyms and Abbreviations 331
- Glossary 332
- List of Terms 333
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.079 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern