Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 36)

The AOS-W Instant CLI allows CLI scripting in several other sub-command modes to allow the users to configure

individual interfaces, SSIDs, access rules, and security settings.

You can use the question mark (?) to view the commands available in a privileged mode, configuration mode, or sub-

mode.

Although automatic completion is supported for some commands such as configure terminal, the complete exit

and end commands must be entered at command prompt.

Applying Configuration Changes

Each command processed by the Virtual Controller is applied on all the slaves in a cluster. The changes configured

in a CLI session are saved in the CLI context. The CLI does not support the configuration data exceeding the 4K

buffer size in a CLI session. Therefore, Alcatel-Lucent recommends that you configure fewer changes at a time and

apply the changes at regular intervals.

To apply and save the configuration changes at regular intervals, use the following command in the privileged mode:

(Instant Access Point)# commit apply

To apply the configuration changes to the cluster without saving the configuration, use the following command in the

privileged mode:

(Instant Access Point)# commit apply no-save

To view the changes that are yet to be applied, use the following command in the privileged mode:

(Instant Access Point)# show uncommitted-config

To revert to the earlier configuration, use the following command in the privileged mode.

(Instant Access Point)# commit revert

Example:

(Instant Access Point)(config)# rf dot11a-radio-profile

(Instant Access Point)(RF dot11a Radio Profile)# beacon-interval 200

(Instant Access Point)(RF dot11a Radio Profile)# no legacy-mode

(Instant Access Point)(RF dot11a Radio Profile)# dot11h

(Instant Access Point)(RF dot11a Radio Profile)# interference-immunity 3

(Instant Access Point)(RF dot11a Radio Profile)# csa-count 2

(Instant Access Point)(RF dot11a Radio Profile)# spectrum-monitor

(Instant Access Point)(RF dot11a Radio Profile)# end

(Instant Access Point)# show uncommitted-config

rf dot11a-radio-profile

no legacy-mode

beacon-interval 200

no dot11h

interference-immunity 3

csa-count 1

no spectrum-monitor

Instant Access Point# commit apply

Using Sequence Sensitive Commands

The AOS-W Instant CLI does not support positioning or precedence of sequence-sensitive commands. Therefore,

Alcatel-Lucent recommends that you remove the existing configuration before adding or modifying the configuration

details for sequence-sensitive commands. You can either delete an existing profile or remove a specific

configuration by using the no… commands.

The following table lists the sequence-sensitive commands and the corresponding no command to remove the

configuration.

AOS-W Instant 6.3.1.1-4.0 | User Guide Setting up an OAW-IAP | 36

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 334 335

Kommentare zu diesen Handbüchern

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 36

Kommentare zu diesen Handbüchern