Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 35)

35 | Setting up an OAW-IAP AOS-W Instant 6.3.1.1-4.0 | User Guide

When you use a provisioning Wi-Fi network to connect to the Internet, all browser requests are directed to the AOS-

W Instant UI. For example, if you enter www.example.com in the address field, you are directed to the AOS-W

Instant UI. You can change the default login credentials after the first login.

Specifying Country Code

This procedure is applicable to the OAW-IAP-ROW (Rest of World) variants only. Skip this step if you are installing

OAW-IAP in the United States, Japan, or Israel.

The Country Code window is displayed for the OAW-IAP-ROW (Rest of World) variants when you log in to the

AOS-W Instant UI for the first time. You can specify a country code by selecting an appropriate option from the

Please Specify the Country Code drop-down list.

Figure 2 Specifying a Country Code

For the complete list of the country codes supported by the OAW-IAP-ROW variant type, see Regulatory Domain on

page 322.

Accessing the AOS-W Instant CLI

AOS-W Instant supports the use of Command Line Interface (CLI) for scripting purposes. When you make

configuration changes on a master OAW-IAP in the CLI, all associated OAW-IAPs in the cluster inherit these

changes and subsequently update their configurations. By default, you can access the CLI from the serial port or

from an SSH session. You must explicitly enable Telnet access on the OAW-IAP to access the CLI through a Telnet

session.

For information on enabling SSH and Telnet access to the OAW-IAP CLI, see Enabling Terminal Access on page

73.

Connecting to a CLI Session

On connecting to a CLI session, the system displays its host name followed by the login prompt. Use the

administrator credentials to start a CLI session. For example:

(Instant Access Point)

User: admin

ode is enabled and a command prompt is displayed. For example:

(Instant Access Point)#

The privileged mode provides access to show, clear, ping, traceroute, and commit commands. The configuration

commands are available in config mode. To move from privileged mode to the configuration mode, enter the

following command at the command prompt:

(Instant Access Point)# configure terminal

The configure terminal command allows you to enter the basic configuration mode and the command prompt is

displayed as follows:

(Instant Access Point)(config)#

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 334 335

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 35