Alcatel-Lucent IAP93 Betriebsanweisung PDF herunterladen (Seite 72)

72 | Initial Configuration Tasks AOS-W Instant 6.3.1.1-4.0 | User Guide

2. Enter the HTTP proxy server's IP address and the port number.

3. If you do not want the HTTP proxy to be applied for a particular host, click New to enter that IP address or domain

name of that host under exceptions list.

In the CLI

(Instant Access Point)(config)# proxy server 192.0.2.1 8080

(Instant Access Point)(config)# proxy exception 192.0.2.2

(Instant Access Point)(config)# end

(Instant Access Point)# commit apply

Upgrading an OAW-IAP Using Automatic Image Check

You can upgrade an OAW-IAP by using the automatic image check feature. The Automatic image checks are

performed once after the AP boots up and every week thereafter.

If the image check locates a new version of the AOS-W Instant software on the image server, the New version

available link is displayed at the top right corner of the AOS-W Instant UI.

If OmniVista is configured, the automatic image check is disabled.

To check for a new version on the image server in the cloud:

1. Go to Maintenance>Automatic>Check for New Version. After the image check is completed, one of the

following messages is displayed:

n No new version available — If there is no new version available.

n Image server timed out — Connection or session between the image server and the OAW-IAP is timed out.

n Image server failure — If the image server does not respond.

n A new image version found — If a new image version is found.

2. If a new version is found, the Upgrade Now button becomes available and the version number is displayed.

3. Click Upgrade Now.

The OAW-IAP downloads the image from the server, saves it to flash and reboots. Depending on the progress

and success of the upgrade, one of the following messages is displayed:

n Upgrading — While image upgrading is in progress.

n Upgrade successful — When the upgrading is successful.

n Upgrade failed — When the upgrading fails.

If the upgrade fails and an error message is displayed, retry upgrading the OAW-IAP.

Upgrading to a New Version Manually

If the automatic image check feature is disabled, you can use obtain an image file from a local file system or from a

TFTPor HTTP URL. To manually check for a new firmware image version and obtain an image file:

1. Navigate to Maintenance>Firmware. The Firmware window is displayed.

2. Under Manual section, perform the following steps:

l Select the Image file option. This method is only available for single-class OAW-IAPs.

The following examples describe the image file format for different OAW-IAP models:

n For OAW-IAP134/135 — AlcatelInstant_Cassiopeia_6.3.1.1-4.0.0.0_xxxx

n For OAW-RAP108/109 and OAW-IAP114/115— AlcatelInstant_Pegasus_6.3.1.1-4.0.0.0_xxxx

n For OAW-RAP155/155P — AlcatelInstant_Aries_6.3.1.1-4.0.0.0_xxxx

n For OAW-IAP220 Series— AlcatelInstant_Centaurus_6.3.1.1-4.0.0.0_xxxx

1 2 ... 67 68 69 70 71 72 73 74 75 76 77 ... 334 335

Keine Kommentare

Alcatel-Lucent IAP93 Betriebsanweisung Seite 72